|
产品说明 Description |
|
醇酸磁漆IS50是一种耐候、光泽良好且具有保色性的醇酸磁漆。漆膜柔韧，耐海水，矿物油及其他脂肪烃类物质。同时，还可耐水冷却区表面的温度。
Alkyd enamel IS50 is alkyd enamel with weather-resistance, good gloss and color retention. It is flexible and resistant to salt water, mineral oil and other aliphatic hydrocarbons. It withstands temperatures as normally existing on water-cooled blocks, etc. |
|
主要特性 Outstanding Characteristics |
|
1. 作为通用面漆，用于中等腐蚀性环境下的钢板或木结构的内、外表面涂布。
2. 作为机房（包括主机及辅助机械）的面漆。
3. 作为机房及类似区域的舱顶面漆。
1. As a general purpose-finishing coat on interior and exterior steel and woodwork in moderately corrosive environment.
2. As a finishing coat in engine rooms, including main engine and auxiliary machinery.
3. As a finishing coat on tank tops in engine rooms and similar areas.
|
|
技术数据 Technical Data |
|
漆 面:
Finish: |
有光 见“备注”
Glossy See remarks |
|
|
颜 色:
Colors: |
白色
White |
黑色 (可按需求提供其它颜色)
Black (other color depending on requirement) |
|
体积固体含量:
Volume solids: |
约49%
Approx. 49% |
约44%
Approx. 44% |
|
理论涂布率:
Theoretical spreading rate: |
约16.3米2/升
Approx. 16.3 m2/L |
约14.7米2/升 (以30微米干膜计)
Approx. 14.7 m2/L (30 micron dry film thickness) |
|
耐 温：
Temperature resistance: |
（干燥）：120℃
Maximum (dry)： |
|
|
闪 点:
Flash point: |
38℃
|
|
|
比 重:
Specific gravity: |
约1.1千克/升
Approx. 1.1 kg /L |
约0.9千克/升
Approx. 0.9 kg /L |
|
指 触 干:
Dry to touch: |
6-8 小时 20℃
6-8 hours |
|
|
施工详述 Application Details |
|
施工方法:
Application method: |
无空气喷涂
Airless spray |
空气喷涂
Air spray |
刷涂
Brush |
|
稀 释 剂:
Thinner: |
TH98 |
TH98 |
TH98 |
|
用量:
Max. Vol.: |
5%
|
15%
|
5%
|
|
漆膜厚度:
Indicated film thickness: |
湿膜: 75 微米
Wet: 75 micron |
干膜: 30 微米
Dry: 30 micron |
|
|
重涂间隔:
Recoat interval: |
最小: 8小时 20℃
Min: 8 hours |
: 5天 20℃ 见“备注”
Max.: 5 days See remarks |
|
施工条件:
Application conditions: |
按照正常要求的良好条件进行。在狭窄空间施工和干燥期间，应大量通风.
As dictated by normal good painting practice. In confined spaces provide adequate ventilation during application and drying. |
|
先涂油漆:
Preceding coat: |
醇酸磷酸锌底漆IP53 或按规定先涂。
Alkyd zinc phosphate primer IP53, or according to specification. |
|
加涂油漆:
Subsequent coat: |
无
None. |
|
备注 Remarks |
|
|
重涂间隔:
Recoat interval: |
重涂间隔与涂覆后的暴露条件有关：（30微米干膜、20℃）
Recoat interval refers to exterior surface exposed in contaminated environment (30 micron dry film thickness, 20℃) |
|
|
|
|
|
|
重涂间隔
Recoat interval |
最小
Min. |
Max. |
|
|
|
重涂油漆
Overcoating with |
大气环境
Atmospheric Environment |
大气环境
Atmospheric Environment |
|
|
|
轻度
mild |
中等
moderate |
轻度
mild |
中等
moderate |
|
|
|
IS50 |
8 小时
8 hours |
8 小时
8 hours |
不限
none |
5 天
5 days |
|
|
|
|
|
如超过重涂间隔，应磨粗表面，以保证附着力。若漆膜在使用期间暴露于污染环境，在涂漆前，须用高压淡水冲洗表面，任其自干。
If maximum recoat is exceeding, roughening of the surface is necessary to ensure intercoat adhesion. Before overcoating thoroughly clean the surface exposed in contaminated environment by high pressure fresh water hosing and allows drying. |
|
|
|
|
安全 Precautions |
|
本产品在施工时应遵守有关的国家卫生，安全和环境标准及其法规。使用前应获取和咨询有关本产品的材料安全数据表。注意包装标签上的安全事项。如果你没有完全理解或你不能严格执行这些安全事项，不要使用本产品。
在施工和干燥期间要采取通风措施，维持溶剂蒸汽的容度在安全极限内，防止中毒或缺氧。小心避免与皮肤、眼睛接触。
All work involving the application and use of this product should be performed in compliance with all relevant national Health, Safety and Environmental standards and regulations.
Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health safety information. |
|
Read and follow all precautionary notices on the Material Safety Data Sheet container labels. If you do not fully understand these warnings and instructions or if you cannot strictly comply with them, do not use this product. Proper ventilation measures must be provided during application and drying to keep solvent vapor concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Take precautions to avoid skin and eye contact (i.e. Gloves, goggles, face masks, barrier creams etc.)
Actual safety measures are dependant on application methods and work environment.
|
|
附注 Other Notice |
|
本说明书有关数据是在标准条件下取得，实际使用时，环境条件可能与之略有不同，以上数据如有改变，以本公司说明书为准，恕不另行通知。
All information in this product data sheet is based on standard conditions and slight variation may occur with different conditions. All information in our company is subject to change without notice. |