|
产品说明 Description |
|
IE10是一种丙烯酸树脂为基料的封闭底漆，专用于涂在施工表面为整个油漆配套提供一个理想的底漆。具有良好的耐水与耐碱性能。
Emulsion sealer IE10 is a sealer based on acrylic resin. Applied on the surface as an ideal primer in paint system. Resistant to water and alkali. |
|
主要特性 Outstanding Characteristics |
|
本品可涂于水泥砂浆、灰泥、水泥石棉板、混凝土的表面。
On surfaces of cement mortar, stucco, cementitious sheets and concrete. |
|
技术数据 Technical Data |
|
漆 面：
Finish: |
有光
Glossy |
|
漆 基:
Binder |
丙烯酸共聚物
Acrylic copolymer |
|
颜 色:
Colors: |
乳白
Off-white |
|
体积固体含量:
Volume solids: |
15%
|
|
理论涂布率:
Theoretical spreading rate: |
10米2/升
Approx. 10 m2/L |
|
闪 点:
Flash point: |
无
None |
|
比 重:
Specific gravity: |
约1.0千克/升
Approx. 1.0kg/L |
|
贮 存 期:
Shelf life: |
储存环境要求凉爽、干燥、避免日晒冰冻。
Store in a cool, dry place without direct sunlight and ice. |
|
颜 料:
Pigment |
无
None |
|
混合比率:
Mixing ratio |
单组分
Single component |
|
漆膜厚度:
Indicated film thickness: |
湿膜: 100微米
Wet: 100 micron |
干膜: 15微米
Dry : 15 micron |
|
干燥时间:
Drying time |
表干：30-40分钟
Set to touch: 30-40 minutes |
实干：2小时
Dry hard: 2 hours |
|
重涂间隔:
Recoat interval: |
最小：2小时
Min.: 2 hours |
：无限
Max.: None |
|
施工详述 Application Details |
|
施工方法:
Application method: |
刷涂、滚涂或喷涂
Brush, roller or spray |
|
稀 释 剂:
Thinner: |
若需要可用清水
Fresh water, if necessary |
|
工具清洗:
Cleaning of tools: |
清水
Fresh water |
|
表面处理:
Surface preparation: |
被涂表面必须清洁、干燥、无油脂或其他油污、无松散涂层。
The surface must be clean, dry and free from loose materials, oil, grease and other contaminants.
|
|
备注 Remarks |
|
施工时温度不低于8℃，相对湿度必须低于85%。
Do not apply at temperature below 8℃, at relative humidity above 85%. |
|
安全 Precautions |
|
本产品在施工时应遵守有关的国家卫生，安全和环境标准及其法规。使用前应获取和咨询有关本产品的材料安全数据表。注意包装标签上的安全事项。如果你没有完全理解或你不能严格执行这些安全事项，不要使用本产品。
在施工和干燥期间要采取通风措施，维持溶剂蒸汽的容度在安全极限内，防止中毒或缺氧。小心避免与皮肤、眼睛接触。
All work involving the application and use of this product should be performed in compliance with all relevant national Health, Safety and Environmental standards and regulations.
Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health safety information.
Read and follow all precautionary notices on the Material Safety Data Sheet container labels. If you do not fully understand these warnings and instructions or if you can not strictly comply with them, do not use this product. Proper ventilation measures must be provided during application and drying to keep solvent vapor concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Take precautions to avoid skin and eye contact (ie. Gloves, goggles, face masks, barrier creams etc.)
Actual safety measures are dependant on application methods and work environment.
|
|
附注 Other Notice |
|
本说明书有关数据是在标准条件下取得，实际使用时，环境条件可能与之略有不同，以上数据如有改变，以本公司说明书为准，恕不另行通知。
All information in this product data sheet is based on standard conditions and slight variation may occur with different conditions. All information in our company is subject to change without notice. |