产品主要参数：
额定电压：380V-50/60Hz
工作环境：温度-30℃-60℃ 湿度45≤90%RH
绝缘电阻：产品的带电件与外漏非带电之间的绝缘电阻应该≥100MΩ
介质强度：R,S,T端子与A,B,C间经AC1500V 漏电流5mA,历时1min无击穿和闪烁现象。
寿命：大于10000次
缺相保护功能：有
过欠压保护功能：有
不平衡功能：有
使用电压范围：460V - 310V
额定负荷：AC380V5A/AC240V8A
Mian Data Of Product:
Rated Voltage: 380VAC,50/60Hz
Working Environment:temperature: -30℃-60℃ Relative humidity: 45≤90%RH
Insulating Resistance:the insulating resistance between living part and exposed uncharged part should be＞100MΩ
Dielectric Strength:applied AC1500V between R.S.T terminals and A.B.C with leaking current of 5mA for 1 minute,it should have no breakdown and flash.
Service life: larger than 10000 times。
Phase-lacking prtective function: available
Over-voltage and under-voltage Protection function：available

Imbalance function:available
Ranger of Applied voltage:450VAC - 310VAC
Rated load: AC380V5A/AC240V8A

过压点：437VAC±2%
过压恢复点：427VAC±2%
过压保护延时：4S
过压恢复延时：4S

欠压点：323VAC±2%
欠压恢复点：333VAC±2%
欠压保护延时：4S
欠压恢复延时：4S

缺相保护电压：＜190VAC±2%
缺相保护延时：＜1S
缺相保护恢复延时：2S

不平衡电压：30VAC
不平衡恢复电压：25VAC
不平衡保护时间：2S
不平衡恢复时间：2S

相序错误保护时间：＜1S
相序错误恢复时间：＜1S

绿色LED指示灯：
亮表示继电器吸合。即输出端A与C连通。
有以下几种情况导致LED灯熄灭，继电器的断开，即输出端A 与C断开。
1.输出端R，S，T接线相序错误.
2.发生了过压,欠压,缺相,不平衡.

Green LED indicator lamp

If the lamp in on, it indicates the relay picks up, that is, the output terminals A is connected to C.

If the following conditions appear, the LED lamp will go out and the relay is switched off, that is, terminal A is disconnected from C.

1.        The phase sequence of output terminals R, S and T is connected incorrectly;

2.            Over-voltage, under-voltage, phase-lacking or imbalance happens.

产品主要用途：
主要适用于中央空调，5匹以上柜机空调,电梯，大型机电产品等。
Main purpose of product:
It is mainly suitable for central air conditioner, air conditioner over 5HP,electric elevator and large-scale mechanical and electric products.

产品特性:
该产品主要是当电网中相序发生错乱,缺相,以及电压高于460VAC,和低于342VAC时,对电器的某些控制线圈进行切断电流,从而达到保护目的.

Characteristics of product
This product can switch off some control coil of the electric appliances in case the phase order is in confuse in the network or phase is lack or the voltage is higher than 460VAC and lower than 342VAC thus to reach the protection purpose.

 保护特点：

动态缺相、静态缺相保护：指被保护设备在运行状态或非运行状态时，任意一相发生断相故障。指示灯形式为：黄灯灭。

错相保护：防止T、S、R三相交流电源相序接错的一种保护措施。即时动作。指示灯形式为：黄灯灭。

过压保护：指被保护线路电压高于设定值。指示灯形式为：LED灯灭

欠压保护：指被保护线路电压低于设定值。指示灯形式为：LED灯灭

Characteristics of protection

Dynamic phase-lacking protection and static phase-lacking protection, which starts to work if one phase opens when the protected equipment is in operating course or un-operating state. The yellow indicator lamp goes out。

Error-phase protection: It is a protection method preventing T, S and R three-phase power supply connecting incorrectly. It can work instantly and the yellow indicator lamp goes out.

Over-voltage protection: means the voltage of the protected circuit is higher than the set value; the LED      indicator lamp goes out.

Under-voltage protection: means the voltage of the protected circuit is lower than the set value; the LED      indicator lamp goes out.

性能特点：

监视器的保护功能能够全性能、全气候长期工作。功耗不大于25W；

本产品通过CE认证

Performance characteri stics:

The monitor can exert its protection function wholly and in any climate for a long time. The power≤25W；

This product has pass CE Certification.

工作特点

T、S、R三相接线正确，监视器黄灯亮，继电器吸合；如果相序接错，监视器黄灯灭。

T、S、R三相或任何一相丢失，监视器黄灯灭，电压正常时恢复，黄灯亮，继电器吸合。

Work characteristics:

If three phases T, S and R are in a correct connection, the yellow indicator lamp is on and the relay picks up; If the phase sequence is connected incorrectly, the yellow indicator lamp goes out

If three phases T,S and R, or any phase loses, the yellow indicator lamp goes out. When the voltage is normal, the yellow lamp is on and the relay picked up.

技术参数：

环境温度：-25~+55℃

相对温度：＜90%

外型尺寸：68mm×30mm×72mm

Technical Parameters

Environment temperature:-25℃~+55℃

Relative humidity :< 90%

Dimension:68mm×30mm×72mm